pure carbon fiber tube - Manufacturers, Factory, Suppliers from China

The molding methods of carbon fiber products mainly include two ways: First, the molding process, the molding is to place the carbon fiber material between the upper and lower molds, under the action of the pressure and temperature of the hydraulic press, the material fills the mold cavity and removes the residual Air, after a period of high temperature and high pressure, solidifies the resin in the carbon fiber material, and a carbon fiber product can be obtained after demolding. This process greatly reduces the production cost, and has high production efficiency, and is suitable for forming carbon fiber products with complex structures. Second, the autoclave forming process, the autoclave is a special container that can withstand and adjust the stability and pressure within a certain range. The carbon fiber prepreg is laid on the surface of the mold coated with mold release agent, and then covered with mold release cloth, suction felt, isolation film, and air felt in turn, sealed in a vacuum bag, and heated and cured in an autoclave. Before, it needs to be vacuumed to check the tightness, and then put into an autoclave for curing and molding under the action of high temperature and high pressure. This process is suitable for load-bearing structural parts that require high mechanical properties. pure carbon fiber tube, Carbon Fiber Insoles, Rc Composite Frame, Octagonal Carbon Fiber Tube,Carbon Fiber Watch Case. The amount of carbon fiber used in the production of carbon fiber tubes and the modulus of carbon fiber are directly related to the physical properties and strength performance of carbon fiber tubes. In general, the tensile strength of carbon fiber tubes can reach more than 3000mpa, which is 10 times that of steel. The above, but its weight is less than 1/4 of that of steel with the same volume. Therefore, the distinctive feature of carbon fiber tube is light weight and high strength, and it has the reputation of "material" since its inception. The product will supply to all over the world, such as Europe, America, Australia,Puerto Rico, Vancouver,Angola, Johannesburg.Health and Safety FAQ: Carbon fiber soot is non-toxic, but mildly irritating to the skin, eyes and lungs, just like glass fiber. We recommend that you wear a dust mask to try to avoid any itching or stinging, especially when cutting or sanding. Edges can be quite sharp, so rubber gloves are also important to prevent cuts and cuts.

Related Products