Excellent quality Carbon Fiber Rectangular Tube – 3K round full carbon fiber boom with red marked circle logo – Feimoshi
Excellent quality Carbon Fiber Rectangular Tube – 3K round full carbon fiber boom with red marked circle logo – Feimoshi Detail:
3K round full carbon fiber boom with red marked circle logo
Features: 3K carbon fiber tube, 100% new, high quality.
High strength and wide application range
Can be used for: frame arm, landing gear, diy drone
Specification: 4 mm 5 mm 6 mm 7 mm 8 mm 9 mm 10 mm…..130mm 150mm ect.
Our tube is roll tube, not pultrusion tube, roll tube was have the longitude and weft yarn, but pultrusion tube only have the longitude, not weft yarn,
so, the strength not as well as roll tubes.
Carbon fiber is very light weight, the strength is steel’s 9 times, but weight was about 1/3 of steel!
My company Specializing in the production of carbon fiber tubes, carbon fiber plates and so on which could be widely used in your Product,
Whatever Quality or price are all attractive.
If you need to Carbon Fiber Tube Related Product You can contact us .
Purchasing the 3K carbon fiber Tube/shaft from Manufacturer-Factory directly. You can buy a high quality products with reasonable price.
Product detail pictures:
Related Product Guide:
The molding methods of carbon fiber products mainly include two ways: First, the molding process, the molding is to place the carbon fiber material between the upper and lower molds, under the action of the pressure and temperature of the hydraulic press, the material fills the mold cavity and removes the residual Air, after a period of high temperature and high pressure, solidifies the resin in the carbon fiber material, and a carbon fiber product can be obtained after demolding. This process greatly reduces the production cost, and has high production efficiency, and is suitable for forming carbon fiber products with complex structures. Second, the autoclave forming process, the autoclave is a special container that can withstand and adjust the stability and pressure within a certain range. The carbon fiber prepreg is laid on the surface of the mold coated with mold release agent, and then covered with mold release cloth, suction felt, isolation film, and air felt in turn, sealed in a vacuum bag, and heated and cured in an autoclave. Before, it needs to be vacuumed to check the tightness, and then put into an autoclave for curing and molding under the action of high temperature and high pressure. This process is suitable for load-bearing structural parts that require high mechanical properties. Excellent quality Carbon Fiber Rectangular Tube – 3K round full carbon fiber boom with red marked circle logo – Feimoshi , The product will supply to all over the world, such as: Accra, belarus, Florida, With the improvement of the production process, carbon fiber board will popularize or replace many metal structural materials, providing the possibility for the lightness and convenience of products.
By Maud from New York - 2017.12.31 14:53
The factory has advanced equipment, experienced staffs and good management level, so product quality had assurance, this cooperation is very relaxed and happy!
By Brook from Austria - 2017.11.29 11:09
Send your message to us:
Write your message here and send it to us
-
factory Outlets for Chamfering Carbon Fiber Cut...
-
Wholesale Price Carbon Fiber Guitar - 100% cus...
-
Factory Cheap Hot Curved Carbon Fiber Tube - c...
-
PriceList for Carbon Fiber Tube Accessories - ...
-
Low price for Fpv Quadcopter - 0.5mm 2.0mm thi...
-
Reasonable price Design Carbon Fiber - 3K 100%...
