stain carbon fiber plate - Manufacturers, Factory, Suppliers from China

Carbon fiber was produced in the early 1950s in response to the needs of cutting-edge science and technology such as rockets, aerospace and aviation, and is now widely used in sports equipment, textiles, chemical machinery and medicine. With the increasingly stringent requirements of cutting-edge technology on the technical performance of new materials, scientific and technological workers are constantly striving to improve. In the early 1980s, high-performance and ultra-high-performance carbon fibers appeared one after another, which was another leap in technology, and also marked that the research and production of carbon fibers had entered an advanced stage.​​ stain carbon fiber plate, Carbon Fiber Wheel Plate, Cut Composite, Carbon Fiber Tube Handguard,Diy Carbon Fiber Tube. The production process of carbon fiber tubes is different, and the strength of the products produced is also different. Taking T700 carbon fiber and resin as raw materials and a carbon fiber tube made by winding molding process as an example, the carbon fiber tube with a size of 1.6*50*500mm is tested, and it can be found that the average compressive strength of the carbon fiber tube can reach 230MPa, which will occur when the load is exceeded. Brittle failure, the strength of the matrix determines the strength of the carbon fiber tube.In the tensile strength test of the carbon fiber tube, it was found that the carbon tube can withstand a tensile strength of more than 800MPa, and the maximum strain is 0.03, and the tensile resistance of the carbon tube is very good.Carbon fiber composite materials have many advantages such as light weight and high strength. Carbon fiber tubes can be made by winding, rolling, and pultrusion. The product will supply to all over the world, such as Europe, America, Australia,Swansea, Kuala Lumpur,Bolivia, El Salvador.In general, grinding and filing can grind the edges of sharp carbon fiber boards to a smooth appearance. However, if the fiberboard is exposed to harsh environments for a long time, such as marine environments, a two-part epoxy laminate is used to seal the edges.According to the different divisions of carbon fiber precursors, there are generally pitch-based carbon fiber cloth, PAN-based carbon fiber cloth, and viscose-based carbon fiber cloth.Second, according to different specifications, it can be divided into 1K, 3K, 6K, 12K and 24K and above carbon fiber cloth.Third, according to different carbonization, it can also be divided into graphitized carbon fiber cloth, (this carbon fiber cloth can withstand high temperature of 2,000 to 3,000), carbon fiber cloth (can cope with high temperature of about 1,000 degrees), and pre-oxidized carbon fiber cloth (can Resist the high temperature of 200~3 Baidu).Fourth, according to different manufacturing methods, subsequent divisions can be performed. Woven carbon fiber cloth, generally two-dimensional cloth, three-dimensional cloth and three-dimensional woven cloth, etc.; carbon fiber prepreg cloth, including dry and wet prepreg cloth; carbon fiber non-woven fabric, non-woven fabric, also known as chopped strand mat, Continuous felt, surface felt, stitched felt, etc.

Related Products